Q1_Aircraft: Tail Attachment

I'd like to confirm the dimensions of the plates that are used to attach the fuz
and tail, I would hate to make them and find that my plans scale was wrong.
Then I can put the plane back together and sit in it a make brummmmmmmmmmmm
noises. If someone has there tail off could you put the tape measure over one
and let me know please

Mark Fitzgerald
Timaru
New Zealand Q1, noises only

[Non-text portions of this message have been removed]

Thanks Ryan

Mark

[Non-text portions of this message have been removed]

And the material / thickness is...?

John

--- In This email address is being protected from spambots. You need JavaScript enabled to view it. , 'Tri-Q1' <rryan@...> wrote:
>
> Hi Mark,
>
> I measured my plans.
> Length. 1 7/8'
> width.. 1 1/5' (fuselage side) &amp; 1' (tailcone side)
>
> Ryan
>
> --- In This email address is being protected from spambots. You need JavaScript enabled to view it. , 'Kerri &amp; Mark' <ksm@> wrote:
> >
> > I'd like to confirm the dimensions of the plates that are used to
> attach the fuz and tail, I would hate to make them and find that my
> plans scale was wrong.
> > Then I can put the plane back together and sit in it a make
> brummmmmmmmmmmm noises. If someone has there tail off could you put
> the tape measure over one and let me know please
> >
> > Mark Fitzgerald
> > Timaru
> > New Zealand Q1, noises only
> >
> > [Non-text portions of this message have been removed]
> >
>