Q1 Plans Chapter 17 Page 17-11

Details

Category: Quickie Plans

Published: Monday, 12 May 2008 10:28

Written by Dan Yager

Hits: 2279

CARE HEAT MUFF

Begin by making CH3 and CR4. The holes drilled in CH4 is to allow a flange to be bent up to attach CH4 to CH3. Some bending and filing will be necessary to obtain a reasonable fit between CH4 and CH3. The QS100-m24W clamps are used to join the two pieces; RTV is used to seal up the remaining gaps.

The saw cut in CH3 must point forward.

The Aeroduct CAT-5 hose is joined to the CH4 and CH2 with Clamps.