Q1 Plans Chapter 17 Page 17-14
- Details
- Category: Quickie Plans
- Published: Monday, 12 May 2008 10:28
- Written by Dan Yager
- Hits: 2398
THROTTLE
The throttle push-pull control housing is attached similarly to the carb heat control. Mount the CH7 bracket to the firewall.
The original equipment governer control is retained to actuate the throttle control on the carburetor. As the sketch shows, the push pull throttle control is attached to the governor assembly. You may find it desirable to drill several holes in the governor assembly to allow for some variation in the knob stroke for full throttle/idle throttle variation. Once you determine a satisfactory stroke for you, secure the rod.
