Q2 Plans Chapter 15 Page 15-02
- Details
- Category: Q-2/Q-200 Plans
- Published: Saturday, 06 May 2006 20:05
- Written by Quickie Aircraft Corporation
- Hits: 4522
FASTENER INSTALLATION
..... Make 10 of FC1 and 2 of FC2 using the full size patterns provided. Attach the 10 FC11s to the forward fuselage at the 10 locations using AN525-10R10 screws. (2 per fasterner). .....Jig the rear fuselage shell into position flush against the forward fuselage shell using a few dabs of Bondo. By shining a light inside the fuselage at each fastener location in order to see each FC1, drill in the #12 holes (10 locations) for the K1000-3 nutplates. Mount the nutplates to the FC1 fasteners with AN426AD-3-5 rivets, countersinking them flush from the side of FC1 next to the pads. .....Install the AN525-10R10 screws (10 locations) to complete the assembly. That is all there is to it. RUDDER CABLE DISCONNECTS
..... In order to complete making your Q2 trailerable, it is necessary to make quick disconnects for the two rudder cables running aft from the rudder pedals to the tailwheel. A simple method is shown here. To disconnect the cables, remove one of the AN3-5A bolts from each side. .....In practice, to remove the rear fuselage, remove the 10 screws in the aft fuselage shell. Next, pull the forward and aft fuselage shells apart using the slack due to the rudder pedals so that you can remove the AN3-5A bolts indicated above. .....As a final note, if your Q2 has any antennas located in the aft fuselage, they too will need to have quick disconnect fittings. |
||||
END OF CHAPTER |
||||
PAGE
15-2 |