Q1 Plans Chapter 17 Page 17-11
- Details
- Category: Quickie Plans
- Published: Monday, 12 May 2008 10:28
- Written by Dan Yager
- Hits: 2437
CARE HEAT MUFF
Begin by making CH3 and CR4. The holes drilled in CH4 is to allow a flange to be bent up to attach CH4 to CH3. Some bending and filing will be necessary to obtain a reasonable fit between CH4 and CH3. The QS100-m24W clamps are used to join the two pieces; RTV is used to seal up the remaining gaps.
The saw cut in CH3 must point forward.
The Aeroduct CAT-5 hose is joined to the CH4 and CH2 with Clamps.
![Quickie Carb Heat Box Photo Quickie Carb Heat Box Photo](/images/Q1_Plans/Q1_17_11_01.jpg)
![Quickie CH3 Carb Heat Muff Detail Quickie CH3 Carb Heat Muff Detail](/images/Q1_Plans/Q1_17_11_02.jpg)
![Quickie CH4 Carb Heat Outlet Tube Detail Quickie CH4 Carb Heat Outlet Tube Detail](/images/Q1_Plans/Q1_17_11_03.jpg)
![Quickie Exhaust Muff Installation Detail Quickie Exhaust Muff Installation Detail](/images/Q1_Plans/Q1_17_11_04.jpg)