Q2 Plans Chapter 16 Page 16-05
- Details
- Category: Q-2/Q-200 Plans
- Published: Friday, 05 May 2006 20:05
- Written by Quickie Aircraft Corporation
- Hits: 3022
CABLE GUIDES
..... Every push-pull cable except the carb heat control uses a cable guide to provide positive control of cable movement. Make up three cable guides as shown. The mounting bolt hole should be drilled upon assembly later. .....These cable guides function by sizing the hole that the cable housing passes through such that when the AN3-14A bolts are tightened, pressure will be exerted upon the cable housing, preventing slippage. Care must be exercised not to put excessive pressure on the housing, which might damage the cable. .....Throttle cable: rivet a piece of the 3/4" x 3/4" X 1/16" aluminum angle to the oil cooler mount, as shown, using BSP42 rivets. Don't rivet through the oil cooler! Then, attach the cable guide and install the throttle cable. A sketch is included to assist you in hooking up the throttle cable to the throttle body arm. .....Cowl Flap cable: bolt the cable guide to the firewall such that it can assist the cowl flap actuation. A sketch is included showing the arm on the cowl flap and attachment of the cable. .....Mixture control cable: again bolt the cable guide to the firewall so that the mixture control can be actuated. .....Carb heat: this control is potted into the firewall with silicone or 5-MIN and attached to the carb heat control arm. |
||||
|
||||
PAGE
16-5 |